OKUMA "CADET" CNC TURNING CENTER
New 1994, Serial No B972, Model LNC8, Series "CADET"
EQUIPPED WITH:
OSP #5020L CNC Control
#ASA A2-6 Spindle Nose
Collet Chuck - 2-Axis Design
Hydraulic Tailstock
12 Position #V12 Turret
Chip Conveyor
Tooling (Jaws, Collets, ETC)
CATALOGUE SPECIFICATIONS:
Bore Diameter........................... 2.2"
Swing Over Bed, Maximum................. 15.75"
Turning Diameter, Maximum............... 9.84"
Turning Length Maximum, Chuck Work...... 9"
Turning Length Maximum, Shaft Work...... 19.69"
X-Axis Cross Slides Travel, Below
Centerline.............................. 5.12" & 1.77"
Z-Axis Carriage Travel.................. 20.47"
Tailstock Quill Travel.................. 4.72"
Tailstock Quill Diameter................ 3.54"
Tailstock Quill Taper................... #5 MT
Spindle Speeds, Range................... 75 to 4200 RPM
Cutting Feedrate, Range................. .01 to 40 IPM
X-Axis Thread Feed, Maximum............. 236 IPM
Z-Axis Thread Feed, Maximum............. 354 IPM
Rapid Traverse Rate, X & Z-Axis......... 472 IPM
Spindle Motor, Horsepower............... 10 HP
Floor Space Required, L x D............. 8'10" x 6'1"
Weight, Approximately................... 10000 LBS
